Stainless Steel Hose Nozzle with Male Thread
1 to 20 (from a total of 20)
Stainless steel hose nozzle with external thread.
Available in sizes from ¼ inch to 2 inches with the grommets ranging from 6mm to 50mm.
- Male thread x grommet
The component is provided with a Withworth pipe thread, which can be easily attached to another material such as brass or PVC.
Also, use the matching thread sealant such as PTFE thread sealing tape, thread sealing thread or sealing hemp.
No slippage with three barbs.
Our stainless steel threaded fitting series hose nozzle has a total of three barbs, which reliably eliminates one of the most common problems. - The hose slips off the grommet. To prevent the end of the hose from slipping off the hose nozzle when watering, first make sure that you push, for example, the connected garden hose to the stop of the nut of the component.The three barbs support the retention on the component.Hose nozzle not tight?
The corrugation of the grommet side already provides a stable hold, but does not prevent the hose from slipping off at higher pressures.Therefore we recommend the use of a worm drive clamp.
This encloses the hose and presses it against the outside of the hose nozzle.
If you want to connect a particularly hard or inflexible hose to your stainless steel hose nozzle, you should use a hinge pin clamp, as this has a higher tightening torque.
Technical Details:
-
Stainless steel hose nozzle with male thread
-
Dimension from ¼ inch to 2 inch
- AISI 316 V4A stainless steel
- Withworth pipe thread